KTM Radiator Guard Installation Instructions for 1998-2003 2-Strokes 125/250/380, SX, Part #12-10

Parts included:    1 set rad. guards                                 1 cross bar assy.

                          4 ea. 6mm x 14mm shcs                      2 ea. 6mm x 8mm fhcs

                          1 #20 hose clamp                                2 ea. 6mm x 20mm

                                                                                      hex/washer bolt

1.      Remove seat, side shrouds, & tank.

2.      Remove stock louvers and set aside. Remove stock bolts from radiators and set aside.

3.      Install long bracket & “L” bracket assembly above the frame tubes. (as shown in picture #1) Note: pull radiators off of frame mount pins to allow additional room to get brackets snaked through and remount once you have bracket in position.

Picture #1

4.      Clamp small “L” bracket to the top of the lower frame tube using the #20 hose clamp provided.             (as shown in Picture #1)

5.      Bolt radiator guards in place using 6mm x 14mm bolts provided. Tip: A ball-end hex allen wrench is the easiest way to install using access holes provided!  Tip: Be sure to start bolt straight! Install 6mm. x 8mm flat head cap screws through radiator guards into long bracket ends. (as shown in picture #2) Use Loctite and do not over tighten!

Picture #2

6.      Reinstall tank, side shrouds (using 6mm x 20mm hex/washer bolts) and seat.

7.      Roost!                                              

For questions or comments, contact us at 1-877-375-5527 toll free or

e-mail to Support@FlatlandRacing.com